Installing and pairing a TSP100IIIBi printer on Windows
Introduction:
How to install futurePRNT software and pair TSP100IIIBi on a Windows device.
Supported Printers: TSP100IIIBi
Supported Interfaces: Bluetooth
Installing futurePRNT software on a Windows device
Download TSP100 FuturePRNT software from the Star Micronics website: Star Micronics Global Support
Right-click the downloaded zip folder and choose “Extract All”.
Once the files are extracted, open the folder if it is not open already.
Right-click the file named “Autorun” and run as administrator (The file type is Application).
Click “Run”.
Click “Run”.
Check “Installation”.
Click “Accept”.
Allow this program to make changes if asked.
Click “Next”.
Make sure “Typical” is selected then click “Next”.
Make the box is checked and click “Install” so that you can check out the Star Cloud Services while the software is installing.
Click “Run”.
Click “Finish”.
Pairing the TSP100IIIBi and creating a driver
Do a self-test on the printer. With the printer off, hold down the feed button. While holding the feed button, turn the printer on. Release the feed button after the printer starts to print.
Take note of the Dev Name on the second printout.
In Devices and Printers in the control panel, add a device.
Select the Dev Name from the list of devices then click “Next”. The printer’s pair with be installed.
Click “Close”.
Open LAN & Bluetooth Setup Tool from your Star TSP100 folder.
Allow access if asked.
The printer should appear in the list of Star devices. It can be identified by its Dev Name. Click Printer Queue.
Check Print Test Page and click “Apply”.
Click “Yes”. A Windows Test Page should print.
Check Devices and Printers to see if both the pair and driver are installed
Congratulations! The TSP100IIIBI is installed.