How to Adjust Paper and Label Settings on an mC-Label Series Printer

Introduction

This article provides instructions for adjusting the print media (paper and label) settings using the Star Quick Setup Utility. Media refers to the type of paper or labels loaded in the printer. The media setting must match the type of media being used to ensure the printer correctly detects and feeds the media.

Supported Printers: mC-Label Series
Supported Interfaces: Bluetooth, Ethernet (LAN), USB, Wi-Fi
Supported Environments: Android, iOS

Before You Begin

• Ensure the printer is powered ON and connected to the mobile device.
• If multiple printers are available, perform a hardware self-test to identify the printer’s IP address or Bluetooth name. Refer to:
  How to Print a Self-Test on Star Printers

Download Star Quick Setup Utility

Star Quick Setup Utility for iOS

Star Quick Setup Utility for Android

When should I adjust print media settings?

Adjust the print media settings when using the printer for the first time or when changing the type of paper or labels loaded in the printer. The media setting must match the type of paper or labels being used.

Adjust the Print Media Settings

1. Open the app and tap Selected Printer.

2. Allow the requested permissions. Select the printer and tap Yes to confirm.

Bluetooth: BD Name
LAN/Wi-Fi: IP Address

3. Select Device Settings, then tap Print Media Settings.

4. Select the appropriate media type then tap Next.

5. If applicable, enable or disable Black Mark Detector, then tap Next.

Note: Select Black Mark only when using black mark paper. Selecting Black Mark with standard paper may cause the printer to malfunction.

6. If applicable, install the paper roll guide and load the new paper. Tap Apply.

7. The settings are saved. Tap OK to exit.

8. Perform a hardware self-test to confirm the new settings. Refer to:
How to Print a Self-Test on Star Printers

Congratulations! You have successfully adjusted the Print Media Settings on the mC-Label.

See Also

What is the Difference Between Diamond, Full and Permanent Label Paper
How to Adjust the Paper Taken Sensor on an mC-Label
How to Adjust Paper Width Using the Star Quick Setup Utility